Now you can add LED for your ride and not worry about seeing a burnt out bulb indicator with our 25 Ohm 25 Watt LED Load Resistor. You can use this load resistor for any LED bulbs.

LED bulbs may cause some newer vehicles to indicate a bulb is burnt out (because of their low power consumption). Some cars indicate this by turning on a bad bulb indicator. This can be remedied with our Load Resistors wired across the LED bulbs to simulate a filament bulb load.
This 25 Ohm, 25 Watt resistors can be connected across the turn signal bulbs to simulate the load of a regular filament bulb (2 Amp load). This will solve LED related turn signal problems such as burnt out bulb indications. This LED Load Resistor can be use with most signal or brake light which uses SINGLE or DUAL FILAMENT LED light bulbs, like the 7443, 1157, 3157, 4157, 1156, 7440, 3156, 194, Dome 1.25, Dome 1.5, Dome 1.75 and etc. Kit Includes gel filled moisture resistant splice taps.
CONNECTION INSTRUCTIONS:
Using included splice taps, connect one wire to ground and the other wire to the turn/brake hot wire. Splice taps allow for installation without cutting your turn signal wires.
Automotive LED Light Bulb Load Resistor Features:

• Solve LED related problems such as turning off burnt out bulb indications.
• Compact design for easy installation.
• 25 Ohm 25 Watt resistors can be use will most import and domestic vehicles.
  

See how to install the Load Resistor click here.